Akbarpoor, I., Resalti, H., Solimani, A. (2011). Investigation of Substituting the organic complex of sulvy-x rather than sodium silicate in CMP pulp bleaching of Mazandaran wood and paper industries. , 26(3), 411-428. doi: 10.22092/ijwpr.2018.117197
Iman Akbarpoor; Hossein Resalti; Ali Solimani. "Investigation of Substituting the organic complex of sulvy-x rather than sodium silicate in CMP pulp bleaching of Mazandaran wood and paper industries". , 26, 3, 2011, 411-428. doi: 10.22092/ijwpr.2018.117197
Akbarpoor, I., Resalti, H., Solimani, A. (2011). 'Investigation of Substituting the organic complex of sulvy-x rather than sodium silicate in CMP pulp bleaching of Mazandaran wood and paper industries', , 26(3), pp. 411-428. doi: 10.22092/ijwpr.2018.117197
Akbarpoor, I., Resalti, H., Solimani, A. Investigation of Substituting the organic complex of sulvy-x rather than sodium silicate in CMP pulp bleaching of Mazandaran wood and paper industries. , 2011; 26(3): 411-428. doi: 10.22092/ijwpr.2018.117197

Investigation of Substituting the organic complex of sulvy-x rather than sodium silicate in CMP pulp bleaching of Mazandaran wood and paper industries

تحقیقات علوم چوب و کاغذ ایران
Article 1, Volume 26, Issue 3 - Serial Number 36, September 2011, Pages 411-428    PDF (292.55 K)
Document Type: Research Paper
DOI: 10.22092/ijwpr.2018.117197
Authors
Iman Akbarpoor* 1; Hossein Resalti2; Ali Solimani3
1M.Sc. Graduate of Pulp and Paper Industries, Gorgan University of Agricultural Sciences and Natural Resources
2Associate Professor of Pulp and Paper Technology, Gorgan University of Agricultural Sciences and Natural Resources, Department of Pulp and Paper Industries
3M.Sc. Graduate of Pulp and Paper Industries, an Expert of Mazandaran Wood and Paper Industries
Abstract
In this study, the effect of elimination and relative decrease of sodium silicate along with substituting the organic complex of sulvy-x was investigated on optical properties of CMP pulp bleached by hydrogen peroxide. The brightness of paper were increased to 66.8%, yellowness decreased to 22% and opacity decreased to 80% with increase in sodium silicate charge from 0.7% to 3%. Also, with complete elimination of sodium silicate and using of sulvy-x at different levels of 0.4, 0.5, 0.7 and 1% , highest brightness and lowest yellowness were shown at 0.5% sulvy-x. These values were 66.1% and 21.8%, respectively. The brightness of paper enhanced from 61.2% to 67.3% with increasing of sulvy-x charge from 0.4% up to 0.5% blended with constant value of 0.7% sodium silicate. But the brightness decreased at higher levels. Generally, pretreatment by DTPA prepared the paper with lower brightness and higher yellowness at two different states namely silicate-free and silicate-containing with sulvy-x. Pretreatment by DTPA at silicate-free state led to decrease of opacity but at silicate-containing state terminated to improve of opacity values. Increasing of bleaching time up to 120 minutes resulted in the paper with higher brightness, higher opacity and lower yellowness at silicate containing state with sulvy-x. At silicate-free state, increasing of bleaching time up to 120 minutes led to improve of opacity while brightness improved and yellowness reduced with increase in bleaching time to 90 minutes. Also, the brightness of paper decreased at higher times (120 minutes) and yellowness increased. In conclusion, achieved results from comparison of optical properties of paper produced from peroxide bleaching of hardwood CMP pulp indicated that we could produce the paper with desirable or even better optical properties by replacing of sulvy-x rather than sodium silicate compared to conventional peroxide bleaching.
Keywords
Sodium silicate; organic complex; sulvy-x; CMP pulp; brightness; yellowness; OPACITY
References

- اکبرپور، ا؛ رسالتی، ح.1387. بررسی جایگزینی کمپلکس آلی گلاناپون به جای سیلیکات‌سدیم در رنگ‌بری خمیرهای CMP مخلوط پهن برگان با پروکسیدهیدروژن. مجموعه خلاصه مقالات اولین همایش ملی تأمین مواد اولیه و توسعه صنایع چوب و کاغذ کشور، دانشگاه علوم کشاورزی و منابع طبیعی گرگان، صفحه 34.

- میرشکرایی، ا.1382. فناوری خمیروکاغذ(تألیف گری اسموک). انتشارات آئیژ تهران. چاپ دوم. صفحات      215-213.

-Dehghani, M.R. 2004. Preparation of Bleached Chemi-thermo mechanical pulp from birch. Ph.D Thesis, Forest State University, Moscow, pp: 90-120.

-Hietanen, Tomi., Tamper .Juha., and Manner Hannu.2007.Alternative Alkalis in Peroxide Bleaching of Mechanical Pulp. Laboratory of Paper Technology, Lappeenranta University of Technology, Finland, P:1-5.

-Knecht, Johannes.2007.Magnesium Hydroxide: An Alternative Alkali Source in Hydro peroxide Bleaching of Wood. International Mechanical Pulping Conference Proceedings.85457 Horkofen, Germany, P:1-4.

-Marchtrenk and Walterstrasses.2006.EN Iso 9001.www.Glanapone stab.com.

-Pan,George X.2002.Pulp yield loss in alkaline peroxide bleaching of aspen CTMP part: Estimation and impacts. Tappi Journal , 37, :321-334.

-Strunk,W.G.1990.Peroxide bleaching. pulp and paper manufacture. pages 238-251.                                                                                                                                                                                                                                                 

-Suss, H.U., Dell Grosso.M., Schmidt.K., Hopf.B. 2001. Options for bleaching of mechanical pulp with a lower COD load.Appita Annual Conference Proceedings.pp 419-425.                                                                                                                                                           

 

 

 

 

 

 

 

Statistics
Article View: 354
PDF Download: 354


counter
Journal management system. designed by sinaweb